In this episode
- A homemade rig of a phone, two torches and a steel rod weight
- A full camera descent to check the depth and condition of the well
- A 30 metre trench from the house to the meter position
- 25mm ducting inside 50mm ducting for extra protection
- A western whip snake by the garden wall
Real renovations do not look like the shows
This week I lower a camera into the old water well. You have seen the shows: buy a ruin in the Mediterranean, sip a glass of wine watching the sunset, choose some tiles, plump a few cushions, and suddenly it is a show home. Well, real renovations do not look like that.
I bought this villa a year ago. No power, no water, no team behind the scenes. Just me, a vision and a mountain of work. So if you have ever thought about taking on a project like this, watch and decide for yourself whether the dream is worth the reality. My article on what I wish I had known before buying is the honest version.
Building a camera rig for the well
Today I am making a contraption to send down the water well, and I am making it up as I go along. Here is what goes on it:
- A couple of cheap torches, to light the shaft.
- My phone, recording video all the way down.
- A rope, to lower it and pull it back up.
- A steel rod at the bottom, as a weight so the rope goes straight down without problems.
The steel rod will also give me a rough idea of the depth of water in the well. Hopefully it gives me a better understanding of the condition at the bottom and how much water there is. I will also be able to find out for definite whether one of my boys threw his trainers down there, as we have not been able to find them.
At the workbench, I cut and fix the parts together with the drill, cable ties, tape and a clamp, strap the torches and phone into position, test the beams and tie on the rope.
Lowering it down the well
Out in the garden, I kneel down, lift off the round well cap and set it to one side. Then the rig goes down the stone lined shaft on its rope. The footage shows the walls of the well passing by, then the rig reaches the murky water at the bottom and dips in, before I haul it back up and sit down to watch the recording on my phone.
The well comes up again and again later in the renovation. I build the terrace walls around it in episode 39, and rebuild it with terracotta bricks in episode 46. Later still, it becomes one of the villa's two independent water sources, alongside the underground rainwater tank from episode 76.
A morning kitten break
On the front steps, the mother cat and two kittens are playing on the stairs and the wooden plank ramp, so I stop for a while to give them some attention. I rescued sick kittens in episode 38.
Digging the trench for the main power supply
This might look like just another trench, but it marks a big step forward. I am laying the duct for the main power cable, so the electrician can finally connect the house to the electricity grid. There has been a lot of groundwork to get to this point, literally.
I have planned ahead to avoid any issues later, when I start the landscaping. The ducting runs about 30 metres from the house through a trench, crosses through a footing and then follows alongside it inside one of the planter beds, all the way to the garden wall, where the meter will go. Those planter bed footings were dug in episode 21 with this cable in mind.
I dig the route with a hoe and shovel alongside the villa wall and the flowerbed. Where buried rock and old concrete block the line, I break them out with the demolition hammer and clear the debris by hand and trowel, then keep digging deeper around the corners and the pipe entry points. Finally I run a long tape along the trench to work out how much ducting I need.
Double ducting the main power line
The main duct is 50mm, and it will carry the mains power cable as well as the cables for the garden lights and the electric gate. To give the cables extra protection, I am running 25mm ducting inside the 50mm ducting.
- Unroll the 50mm ducting along the garden and measure out 30 metres.
- Unpack the 25mm ducting and feed it inside.
- Feed a trace line through, so the electrician can pull the cables through once it is buried.
- Lay the ducting into the trench, from the side of the villa to the front gate.
I sit on a chair by the gate, threading the trace line through by hand. How would you get a trace line through 30 metres of ducting? The second fix electrics came in episode 75. The garden lighting ducting was added in episode 55. My guide to setting up utilities in rural Sicily covers getting connected from scratch.
Backfilling the trench with my son
One of my boys, in his safety goggles and with his mini tools, helps backfill the trench. He pushes the soil in with the hoe while we chat about filling the hole, checking our work and stopping for water. Then we rake the soil smooth along the whole route, leaving the garden level and tidy, and I clear the last of the debris with the wheelbarrow.
A surprise snake
To finish the day, I clear rocks and branches from the garden, just as the kittens' mum spots something by the base of the garden wall: a large black western whip snake, sliding along the flowerbed into the soil. My articles on living off grid in Sicily and solar power for an off grid home show where the villa's power is heading.
Frequently asked questions
How do you see inside an old water well?
I built a rig with a phone recording video, two cheap torches and a steel rod as a weight, then lowered it down my well on a rope.
Why put a weight on a well camera rope?
The steel rod on my rig kept the rope going straight down without problems, and it gave me a rough idea of the depth of water in the well.
Why put ducting inside ducting for a mains cable?
I ran 25mm ducting inside my 50mm ducting to give the cables extra protection on the 30 metre run from the house to the meter.
What is a trace line in cable ducting?
It is a line fed through the ducting before it is buried, so the electrician can use it to pull the cables through later.
More episodes on the same job: Rewiring and electrics · Water and plumbing



