In this episode
- Terrace ducting moved so it comes up inside the outbuilding, not under its wall
- A removable wooden well cover with a rope handle
- Custom hinges cut from flat bar and fixed with anchor resin
- An old iron nail restored as a feature inside the well
- Prickly pears picked straight from the cactus and tasted for the first time
Still over 30°C
This week I clean out the old water well and make it a proper cover. It is still hitting 30°C and more here, so I pick up a big floor fan to keep my boys cool while they are here for the next few weeks. Then it is out to the rear terrace.
Moving the terrace ducting
The ducting I laid in episode 44 to link the house to the future outbuilding comes up right where the outbuilding wall will be. I need it to come up inside the building instead. So I break out the concrete around it with the demolition hammer, cut the orange pipe with a reciprocating saw, reroute the red and blue pipes inside the line of the wall and clear the rubble. Learning as I go, mistakes included.
Cleaning out the well and a wooden cover
At the well, finished in episode 47, I vacuum out the debris with the wet and dry vac. The round OSB board I made as formwork in episode 39 is still wedged inside, so I cut it free with a multitool and pull it out. Getting it out would have been much easier if I had just put my fingers underneath and lifted it, but with snakes around, after the skin I found in episode 44, I was not taking the risk.
On the veranda I turn that same board into a removable cover. I mark a slightly smaller circle, trim it with the jigsaw, drill holes in the middle and thread rope through them as a handle, then test it down inside the well.
Hanging the original metal lids
Next, the two original metal lids I restored and primed in episode 47 are test fitted on top of the brickwork. I measure, mark and drill them, trimming the edges with the jigsaw and grinder so they sit right.
To hang them, I make my own hinges:
- Clamp flat steel bar to the workbench and cut the strips to size with the angle grinder.
- Smooth the edges on the belt sander and round off the ends with the grinder.
- Drill the screw holes, then test fit the hinges with bolts, washers and nuts.
- Fix the hinges into the brickwork with a two part polyester anchor resin.
- Grind the top of the bricks flat where the lids sit, and spray the hinge mounts white.
With everything assembled, the lids open and close on their hinges. My article on off grid versus mains water explains how the well fits into the wider water plan.
An old nail with a new job
I came across a couple of old iron nails. Rather than throw them out, I thought one could live on as a feature inside the well. I clamp it to the bench, wire brush and grind off the rust, spray it satin black, then drill a hole high in the inner brickwork, vacuum out the dust, inject resin and hammer the nail in. A small piece of the house's history, kept.
What the well still needs
That is the well pretty much finished. Next comes a company to drain out more than 20 years of sediment, along with a pair of trainers one of my boys dropped in, then water tests, and then I can finally install the pump. The well water will not be for drinking. It will supply the house after going through several filtration systems, so it will be clean, but for drinking I will stick to bottled water.
Now that the ducting is in and the well is built up, the terrace is ready to be backfilled. I will use the soil dug out for the underground water tank, which saves money and avoids disposing of tonnes of earth. That dig starts in episode 76.
The fruit trees and my first prickly pear
Back on the veranda, the potted fruit trees hit by the heatwave in episode 45 are still struggling. I clear the dead growth and sweep up. It saddens me every time I look at them, but I am not giving up hope. The real test will come in autumn, with fingers crossed for new shoots.
I have wanted to try a prickly pear, fico d'India, since last summer. You can buy them year round here, but I wanted my first taste to be straight from the cactus. I pick them from over the wall with kitchen tongs, swirl them in water, dry them wearing gloves, then peel and taste. The flavour is lovely, not too sweet, somewhere between watermelon, kiwi and pear. I am not keen on all the seeds, but hopefully I will get used to them. My Sicily food guide has more local favourites.
Frequently asked questions
What do prickly pears taste like?
My first one, picked straight from the cactus, was lovely and not too sweet, somewhere between watermelon, kiwi and pear, though it was full of seeds.
How do you pick and prepare prickly pears safely?
I picked them with kitchen tongs, swirled them in a bucket of water, dried them wearing gloves, then peeled the skin off with a knife before eating.
Is well water safe to drink in Sicily?
My well water is for supplying the house after several stages of filtration, not for drinking. I drink bottled water. The well will be drained and the water tested first.
How do you fix hinges into brickwork?
I cut my own hinges from flat steel bar and fixed them into the top of the brick well with a two part polyester anchor resin.
More episodes on the same job: Water and plumbing



