In this episode

  • Tower doorway corners rounded to match the opening downstairs
  • An entrance door held in with steel tabs and no fixings to undo
  • The door refitted outside the reveal so it can be rendered
  • 150mm concrete screws from the UK biting tight into soft stone
  • Timber run-off strips over the boarded windows to keep rain off the fresh plaster

Finishing the tower doorway

This week I take out the front door frame so the doorway can be rendered before plastering. First, the tower door sill I fitted in episode 66 needs finishing. Up on the roof terrace I plane and sand the timber, clean back the mortar and seal the wood with outdoor oil.

I decided to round off the corners of the tower doorway to match the doorway downstairs, which I rounded in episode 50. I love the softness it creates, and with this door being glass, it should help the light flow nicely into the tower. The curved reveals are now ready for rendering.

Cutting out the old entrance door

Downstairs, after shovelling the rubble out to the yard, I turn to the old entrance door into the lounge. Just like the windows I took out in episode 58 and episode 59, there are no fixings to unscrew. The frame is fixed into the stone walls with steel tabs, something I have never come across before.

So, in a respirator, ear defenders and goggles, I cut around the perimeter of the frame with the angle grinder and the SDS hammer drill, breaking through the anchors, until the door comes free and I can push it out. It is carried onto the veranda, where I take off the excess trim with a crowbar and drill.

Refitting the door on the outside

I am temporarily reattaching the door to the outside of the opening. That way, the reveal is left clear so I can render it properly, ready for plastering. I measure the door, cut timber battens and screw extensions onto the edges of the frame, then lift it against the outside of the doorway and fix the framing into the stone.

Ideally the door would open outwards onto the veranda. But that would mean exposed hinges on the outside, and anyone could simply knock out the pins and lift the door off. Not worth the risk. My article on whether Sicily is safe covers how I think about security here.

I brought two boxes of 150mm concrete screws over from the UK, and they have been a lifesaver. The stone is soft enough that I can drill straight into it and get an incredibly tight fixing. At dusk, I fill the gaps around the refitted frame with expanding foam by head torch, with the cats gathered round to watch, and sweep up.

Moving the fruit trees

The veranda is cleared for the work ahead. The large potted fruit trees, which struggled through the intense Sicilian summer, are moved off the veranda to the edge of the garden and the steps, along with the terracotta pots and long timber beams. They have had a hard year since the heatwave in episode 45.

Old window frames for scrap

The old window frames from the last few weeks, along with the shutter debris, are gathered from around the yard and stacked neatly near the tower. They are not going to waste. I have arranged for a local scrap man to pick them up next week, though, as I find out in episode 68, he will not take them with the glass still in.

Keeping the rain off the fresh plaster

A bit of water has been dripping in at one of the boarded windows, because the top of the timber frame is flat. So I go up the ladder and fix a strip of timber above the OSB cover to create a run-off. The last thing I want is water getting onto the fresh plaster. The boarding itself went up in episode 58.

Priming the entrance reveals

With the door now outside the opening, the entrance reveals are clear. I brush them with Mapei primer, ready for the render that gives them a clean, straight edge, the same way I did the window reveals in episode 62 and episode 63.

Refitting the temporary tower door

As it gets dark, the temporary tower door goes back on. Up on the roof terrace, I move a large insulated OSB board into the newly shaped opening, brace it with metal props and screw it securely into place, then check the lights inside the tower.

Back downstairs, the cats get their tinned food, the work table is swept, and the lights go off for the night. The plasterers arrive in episode 70. My article on what I wish I had known before buying and my practical renovation guide both cover the surprises old doors and windows can hold.

Frequently asked questions

Why refit a door on the outside before plastering?

I temporarily fixed my entrance door to the outside of the opening so the reveal was left clear, letting me render it properly ready for the plasterers.

Why not have an outward opening front door?

It would mean exposed hinges on the outside, and anyone could knock out the pins and lift the door off. For me, that was not worth the risk.

What screws work in soft Sicilian stone?

I brought 150mm concrete screws over from the UK. The stone is soft enough to drill straight into, and they give an incredibly tight fixing.

How do you stop rain dripping in at a boarded window?

The top of my temporary frame was flat, so I fixed a strip of timber above the board to create a run-off and keep water away from the fresh plaster.

More episodes on the same job: Windows and doors