In this episode

  • All the indoor air con units fitted, with the house cool at 30 plus degrees outside
  • A 25mm main line around the garden, with 16mm branches to every tree
  • Adjustable drippers, a timer, a water filter and a pressure reducer
  • Pegs for the pipe cut from leftover concrete mesh
  • Nocellara olive trees setting fruit after one or two olives in previous years

The air con goes in

This week I set up a DIY drip irrigation system for the fruit trees, but the first news is inside. The electricians are in fitting all the air conditioning units throughout the villa. They have just gone on their lunch break, so I take the chance to give a quick update. All the internal units are now fitted, and one of the external units is up too, with just one more external unit left to install.

They have left one of the units running, and it is beautifully cool in here, nice and cold after working outside. It is 30 plus degrees out there. Absolutely baking. I have been working in the garden all morning, planting fruit trees into the ground ready for the Sicilian summer and getting plenty of mulch around the base of each one. The units arrived in episode 80.

A bracket for the water filter and pressure reducer

Beside the 2000 litre tank at the side of the villa, I build a wooden bracket to mount the water filter, the pressure reducer and the irrigation pipework. That tank, which I set up in episode 72 and had refilled in episode 80, is the water source for the whole garden irrigation system.

The pressure reducer matters. It brings the pump flow down to a safe pressure for the irrigation pipework. Without it, the pump pressure would be far too high and would blow the fittings clean off the irrigation lines.

Shade covers for the beehives

With the heat building, the two beehives get oversized white roof covers to reflect the heat through the Sicilian summer.

Then I clean up the rear terrace after last week's concrete pour in episode 82, and the overgrown beds either side of the driveway are cut.

How the drip irrigation system works

I have already started laying the main black pipe around the garden. The design is simple, and it is built for an off grid water supply:

  • A 25mm main irrigation line runs all the way around the full perimeter of the garden.
  • Smaller 16mm pipe branches off the main line to each individual fruit tree.
  • Each 16mm branch line has an adjustable dripper, fully adjustable for water flow to each tree.
  • A water filter and a pressure reducer sit between the pump and the pipework.
  • The whole system will run on a timer.

The adjustable drippers are really useful for an off grid setup like this. With trees of different sizes across the garden, I can dial in exactly how much water each one gets. The timer is going to be a huge help, especially when I am back in the UK and not at the villa. My guide to off grid versus mains water and the water usage planner help with working out what a garden like this needs.

Pegs from leftover concrete mesh

To hold the pipe flat on the ground, I make my own pegs. The steel mesh left over from the concrete pour is cut into pegs, which pin the irrigation pipe down along its route.

The Nocellara olive fruit set

A quick update on the Nocellara olive trees. Over the winter, I gave all five a heavy prune. Quite brutal, but very necessary: they had not been maintained or pruned for over 20 years, since the villa was abandoned. I started on them in episode 71.

The main goal was to open up the centre of each tree for light and airflow. As the locals in Sicily say, a bird should be able to fly through the centre of an olive tree. The old school saying here is that you should be able to chuck your hat through the middle. That is exactly what I aimed for, and the results have been really encouraging.

  1. Over the last couple of months, thousands of tiny green balls appeared all over the trees.
  2. Then the trees flowered and pollinated. Nocellara olives pollinate by wind, which is why the bees do not actually help with olive pollination.
  3. After pollination, the flowers dropped and the fruit set began.
  4. Now there are larger green balls forming all over the trees. That is the fruit set, where the olives will grow and develop.

I think this could be a really good first olive harvest at the villa, and I am really pleased, because in all the time I have owned this property, there have only ever been one or two olives produced from these trees. My article on harvesting olive oil from tree to bottle and my guide to what makes Sicilian olive oil different follow where this leads.

Installing the irrigation

All the 16mm pipes are now run to every fruit tree in the garden. I still need to fit the end caps to each pipe and the adjustable drippers to every tree, but first I want to redo and improve the water filter and pressure reducer setup at the side of the villa. The current arrangement is not how I want it long term, so I am rebuilding it properly. Then the order of work is:

  1. Rebuild the filter and pressure reducer setup.
  2. Run water through all the pipework to flush the entire system and clear any debris.
  3. Fit all the drippers and end caps.
  4. Fine tune each dripper for the right water flow to each fruit tree.

Different trees need different amounts of water, and with several fruit tree varieties across the garden, some are going to need significantly more than others. On top of that, the off grid supply is limited. Two thousand litres sounds like a lot, but it disappears fast in 30 plus degree heat with no rainfall, and it has not rained here in weeks. It is a lot better than nothing, though, and the trees need it to survive the summer. My article on growing your own food in Sicily covers how the trees did.

Nesting birds on the trail camera

To finish, the trail camera has caught the birds nesting at the villa. The bird boxes have been busy since sparrows started building in them in episode 77, and there were four chicks in one of them in episode 81.

Frequently asked questions

What size pipe do you use for garden drip irrigation?

I used a 25mm main line around the perimeter of my garden, with smaller 16mm pipe branching off to each fruit tree and an adjustable dripper on each branch.

Why do you need a pressure reducer on an irrigation system?

My reducer brings the pump flow down to a safe pressure. Without it, the pressure would be far too high and would blow the fittings off the irrigation lines.

Do bees pollinate olive trees?

No. My Nocellara olive trees are pollinated by wind, which is why the bees do not actually help with olive pollination.

How should you prune an olive tree?

The aim with my trees was to open up the centre for light and airflow. Locals say a bird should be able to fly through the middle, or you could chuck your hat through it.

More episodes on the same job: Water and plumbing · The garden and fruit trees